The W14x808 is a W-beam reference entry with dimensional and section data reported in metric units. Use the values below when reviewing the shape, checking a drafting model, or comparing it with other W-shape dimensions in the SteelSTD reference.
The entry also identifies AISC 360-16 as the governing reference context. That specification addresses the design, fabrication, and erection of steel structures in the United States. The accompanying DWG resource can support drafting and coordination, but engineering use still requires verification against the project requirements and applicable design workflow.
W Beam
refer to : AISC 16
the American Institute of Steel Construction (AISC) Specification for Structural Steel Buildings (AISC 360-16), which is the 2016 edition of the AISC Specification for Structural Steel Buildings. It provides guidelines and requirements for the design, fabrication, and erection of steel structures in the United States.
Depth : 579.1 mm
Width : 472.4 mm
Web Thickness : 95 mm
Flange Thickness : 130 mm
Root Fillet Radius : 15 mm
Sectional Area : 1535.48 cm2
Unit Weight : 1205.4 kg/m
How to read the W14x808 reference
The listed depth and width describe the overall reported envelope of the W-beam section. Web thickness refers to the thickness of the central web, while flange thickness describes the thickness of the projecting flange elements. The root fillet radius identifies the curved transition between the web and flange, which is important when interpreting detailed geometry in drawings or CAD models.
Sectional area is the cross-sectional area of the steel shape. It is commonly used with material density and design calculations, but it should not be treated as a substitute for a complete member check. Unit weight expresses the listed mass per unit length and can assist with estimating shipping, handling, and framing loads when the applicable project assumptions are known.
Using the dimensions and DWG resource
Before placing the W14x808 in a model, confirm the orientation of the web and flanges, the required connection clearances, and the level of geometric detail needed for the drawing. The root region may matter for connection detailing even when a simplified drafting representation is used.
For broader context, compare this entry with the site’s W-shape terminology, steel section properties, and connection detailing references. The downloadable DWG is useful for drafting coordination, but the local section data and project-specific engineering requirements remain the controlling references for design decisions.
W14x808 frequently asked questions
What type of section is W14x808?
W14x808 is identified in this reference as a W beam. The entry provides its reported geometry, sectional area, and unit weight for reference and coordination.
What does the unit weight describe?
The unit weight is the listed mass per unit length of the section. It can be used in material, handling, and framing-load estimates when combined with the relevant project length and assumptions.
Why is the root fillet radius included?
The root fillet radius describes the curved transition between the web and flange. It helps users interpret the actual section profile and account for the shape near connection or fit-up regions.
Is the DWG file sufficient for structural design?
No. A DWG file supports drafting and coordination, but it does not replace design checks, connection design, material verification, or review by a qualified engineer.
Which reference is identified for this entry?
The source identifies the American Institute of Steel Construction Specification for Structural Steel Buildings, AISC 360-16, as the reference context for the listing.
