The W24x62 is a W-shape steel section identified here using metric dimensional and mass data. This reference page preserves the listed AISC context and provides a practical starting point for checking the section in design, detailing, estimating, or CAD workflows.
Use the source values below as the authoritative local reference for this shape. The nominal designation should not be treated as a substitute for the tabulated dimensions, and final member selection requires verification for the applicable loads, limit states, material specification, and connection details.
W Beam
refer to : AISC 16
the American Institute of Steel Construction (AISC) Specification for Structural Steel Buildings (AISC 360-16), which is the 2016 edition of the AISC Specification for Structural Steel Buildings. It provides guidelines and requirements for the design, fabrication, and erection of steel structures in the United States.
Depth : 602 mm
Width : 178.8 mm
Web Thickness : 10.9 mm
Flange Thickness : 15 mm
Root Fillet Radius : 12.7 mm
Sectional Area : 117.42 cm2
Unit Weight : 92.2 kg/m
How to read the W24x62 reference
The W designation identifies a wide-flange section. The designation is a convenient shape label, while the actual depth, flange width, web thickness, flange thickness, root fillet radius, sectional area, and unit weight are given in the source content. These properties describe the section geometry and mass; they do not, by themselves, establish allowable strength or serviceability performance.
Geometry and design interpretation
The listed depth and width help with envelope checks, framing coordination, and connection detailing. Web and flange thicknesses are relevant when reviewing local detailing, fabrication constraints, and applicable limit states. The root fillet is part of the rolled profile and should be considered when a connected plate, stiffener, seat, or other fitting must bear against the shape.
The listed sectional area can support quantity and mass calculations when used consistently with the stated units. The unit weight is useful for estimating member mass and handling requirements, but it should not be confused with a factored design load or a complete structural resistance property. Refer to the relevant steel section properties, W-shape terminology, and connection detailing references when developing a design or drawing.
AISC reference and CAD workflow
The source identifies AISC 360-16, the 2016 edition of the AISC Specification for Structural Steel Buildings, as the reference for requirements related to the design, fabrication, and erection of steel structures in the United States. Apply the governing project requirements and verify material, design assumptions, fabrication details, and connection behavior before issuing engineering documents.
The available DWG download can help with drafting and layout coordination. Treat CAD geometry as a reference aid: confirm the section identity and critical dimensions against the authoritative data before using the drawing for fabrication, procurement, or analysis.
W24x62 frequently asked questions
What does W24x62 identify?
W24x62 is the designation of a W-shape steel section. The designation is a shape identifier; use the listed metric dimensions and unit weight for the actual reference data on this page.
Are the nominal designation and measured depth the same?
Not necessarily. A nominal shape designation is not a replacement for the tabulated profile dimensions. Check the listed depth and other geometry whenever fit, clearance, or connection detailing matters.
What information is provided for this section?
The source lists depth, width, web thickness, flange thickness, root fillet radius, sectional area, and unit weight. It does not provide every property needed for structural design, so consult the applicable section-property and design references.
Can the DWG be used for fabrication?
The DWG is useful for drafting and coordination, but CAD geometry should be checked against the authoritative section data and project requirements before fabrication or release.
Which specification is referenced?
The page references AISC 360-16, identified in the source as the 2016 edition of the AISC Specification for Structural Steel Buildings. Confirm the edition and project-specific requirements that apply to the work.
